-
View current
newsletter (PDF)
-
Enter your email address below
to subscribe to our newsletter.
|
AP-4: Single Door Gate Controller with a Built-in Receiver
The Model AP-4 Single-portal Access Controller is designed for a broad range of access control applications.
For sites that have a
single entrance or gate, the AP-4 is the ideal wireless-based access control
system. It can be used to remotely activate devices such as gate operators, door
strikes, or door operators.
Typically, the AP-4 is used to control a door strike, barrier gate, automatic gate or automatic door operator.
The AP-4 is small enough to be mounted
within the gate operator.
Highlights:
- Contains a high-gain UHF receiver which uses an external antenna to pick up
signals from up to 250 feet away.
- The AP-4 will retain its memory, even without power.
- Two dry contact relay outputs are provided. One relay is the access relay, which triggers for two seconds each time a programmed transmitter is activated. This relay output connects to the pushbutton or radio input of the access device. The second relay is the
obstacle relay, which triggers for two seconds when an obstacle signal is sent from a safety edge transmitter. This relay output connects to the obstacle input of the access device.
- An
open request input terminal is supplied for hardwired activation of the access device with an external pushbutton or keyswitch.
- The AP-4 can be powered from 12-24 Volts AC or DC. The Form C relay outputs can switch up to 1 Amp each. An
earth ground terminal is provided as an optional connection for maximum lightning and static protection.
Features:
- Ideal for gated communities, parking facilities, and industrial sites
- Easy to set-up and use
- Easy to add, suspend, and delete individual transmitters through programming
mode - no transmitter dip switch to set.
- Supports 480 block coded transmitters or 239 individual transmitters/ wireless keypad entry codes.
Remote transmitters can be programmed with a few keystrokes.
- One fully supervised safety edge transmitter can be programmed
into the AP-4’s memory.
- Easy to add, suspend, and delete transmitters through programming mode, no transmitter dip switches to set
- RF frequency: 318 MHz
- 4.45" W x 5.75" H x 1.5" D (without antenna)
|
