Fire Counter ShuttersFire Counter Shutters



Fire Doors - Fire Counter Shutters


All-Rite offers a wide selection of fire counter shutters to suit any type of installation. Our fire shutters and fire doors are designed to withstand frequent testing without subjecting any parts to impact. They are designed to withstand the effects of our Canadian conditions providing years of trouble free protection. Our FD10 Series Counter Fire Doors meet today's architectural demands for beauty, reliable performance, and fire safety.


Many metropolitan areas, like Brampton, Toronto and much of the GTA, have buildings that are in very close proximity. These buildings are required to comply with the Ontario Fire Code in relation to fire safety. The Fire Code requires that buildings install and maintain fire shutters in certain circumstances.

Fire roller shutters operate similarly to a standard steel roller shutters. The difference is in the construction of the fire shutters. Heavier materials and more fixings are required. The fire shutters support structure must also be fire rated to the same or greater resistance. All materials should have appropriate test certification. Fire shutters require little space and are a comparatively economical solution to providing fire separation in buildings.

All-Rite’s sales and service professionals can advise you regarding fire shutters and compliance with any fire safety requirement (Building Code, National Fire Code, National Fire Protection, building management).

Whether you require fire doors or fire shutters for a new construction project or for an upgrade/replacement for a building retrofit, All-Rite will recommend the best fire door solution for your specific needs.

Rolling counter fire doors (also called fire shutters) feature the following:

  • Compact mechanical governor controls automatic closing speed to a range of 6" to 2' per second
  • Oil tempered torsion springs designed for 20,000 life cycles
  • Available for 3 hour, 1½ hour and ¾ hour ratings
  • Approved in sizes to 96 square feet not exceeding 14' wide and 9' high
  • Approved for all wall types (concrete, masonry, structural steel, structural steel with gypsum board, gypsum wall partition with minimum 16 gauge metal stud)
  • Reset from one side of opening reducing testing costs
  • Sure-Close release spring increases reliability of automatic closings
  • Testing doors in fully closed position will not damage mechanisms

Choice of Finishes

  • FinalCote steel
  • ColorCote in 180 standard colors
  • #4 polished stainless steel

Choice of Operation

  • Push-Up - limit 9' wide
  • Crank
  • Motor

When the automatic closing of the FD10 is coordinated with a building fire alarm of smoke detector system, the counter fire door can be connected to All-Rite's TEST-A-FIRE, FireFly and SureFire Fire Door Release Systems. These fire protection devices enhance the built-in protection of the FD10.

Firestop Counter Tops

Known for its contemporary styling and reliable performance, All-Rite's rolling counter fire doors provide the same degree of fire protection as the full-sized rolling service fire door. As with our standard counter doors, counter fire doors are engineered with properly sized components and trim.

All-Rite's fire-rated counter tops complete the fire protection package and eliminate the "envelope" for fire to gain entry to the other side of the wall.

“Firestop" Counter Tops, tested and labeled for 1½ hour ratings on interior openings, are the only laminated, fire-rated counter tops available. For maximum fire protection, FireStop counters are recommended for use with all All-Rite's FD10 counter fire doors, and are specifically required by authorities in many municipalities.