-
View current
newsletter (PDF)
-
Enter your email address below
to subscribe to our newsletter.
|
Series 0401 Stationary Rigid Door Shelter
 The
0401 is perfect for dock openings up to 11' x 10'. It is one of
the most versatile shelters available. The Series 0401 allows complete and
unobstructed access to the full width and height of the trailer interior
and shipping door while providing outstanding weather protection.
It covers a wide variety of door sizes and handles an even wider variety
of trailer sizes. The 0401 requires little maintenance or service
and has an extremely long life span.
The frame is made with sturdy galvanized tubing that will not warp, rot
or twist. The unit sides and
top are covered with rigid translucent plastic. A tight seal is
maintained against the sides and top of the trailer body through spring
like fiberglass stays built into the side and top curtains as well as a
foam bead at the leading edges.
A large selection of tough abrasion
resistant fabrics -- including vinyls,
hypalons and neoprenes -- makes
this unit an excellent long lasting investment
The Series 0401 creates a tight
seal that blocks out foul weather, insects, dust, dirt, and may reduce pilferaging,
while saving money on energy costs.
Highlights: (see
Component Diagram)
- Series 0401 standard dimensions for door openings 11' wide x 10' high
are 11'6" wide x 11'0" high x 24" projection with 21" wide vertical panels
and a 36" drop header panel.
- With a dock height of 48", the 0401 seals trailers from 11'6" to 13'6" high
from grade. Also seals trailers with width from 8'0" wide.
- A large selection of quality cover fabrics available including our exclusive SS-90
high performance vinyls.
- Can be designed to suit a large variety of oversized door opening heights,
widths and/or dock projections.
- 18"-20" projection in front of the dock bumper face is recommended to
provide a proper seal.
Features:
- Heavy-duty wolmanized wood frame with translucent fiberglass top and sides
allows natural light into the dock area.
- Best suited for typical door sizes up to 12' x 12' with 12" minimum of
shelter past the face of the dock bumpers
- Unit framework is constructed of 1½" x 1½" galvanized
tubing covered with galvanized cladding.
- The header framework is peaked to allow for adequate
drainage and to prevent water from standing on top.
- The vertical panels contain fiberglass stays, the top
three being in a "Z" pattern to keep the curtain straight at all times.
- Vertical panels have a double layer of fabric at the
leading edge impact area and a 4" wide x 14" high yellow guide stripe to aid in
spotting shelters.
- The header panel has full height fiberglass stays and
overlapping protective flaps at trailer impact areas.
- The header panel has elastic wind straps to keep the
panel in position. All stays are enclosed in multi-layer reinforcement
pockets and maintain pressure against side and top of trailer
- Leading edges of vertical and header panels have a sewn
in foam bead which conforms to trailer for better seal.
- Double stitched, high strength twisted, 4 ply 100%
polyester bonded thread U.V. treated used for sewing throughout.
- All exterior front fame edges are trimmed with aluminum
angle to provide a neat, clean finish.
- Wind cord prevents head curtain from blowing out of position. Three
overlapping 40-oz. vinyl wear pleats in comers absorb impact of sharp trailer
edges
- Foam-filled draft pads inside lower comers prevent air from entering; "NO
STEP" safety logo permanently affixed
- Heavy-duty 6" steel bumper guards support frame and provide protection
from incoming vehicles
- Unit is furnished with all necessary mounting hardware,
galvanized to resist corrosion.
|
